ACR Electronics GlobalFix Y1-03-0233 Manual do Utilizador descarregar pdf (Página 36)

Y1-03-0233 Rev. D 35

This message appears if Self-Test has passed. The display indicates that the external GPS did

not update its coordinates during Self-Test.

NOTE: If external GPS data cannot be acquired, typically due to the external GPS not having

achieved a good fix, it does not affect the pass status of Self-Test. Self-Test requires GPS engine

readiness but does not require that the GPS obtain coordinates.

If one of the six tests fails, the system advises you that Self-Test has failed.

This message appears if Self-Test failed. The system advises you to refer to this Product Support

Manual (User Book) for information on what to do and who to contact.

This message appears if Self-Test failed. The system advises you to seek service from an

authorized Service Center. Not only should the beacon be fixed immediately, it also should not be

placed into service until the problem is addressed.

NOTE: “SEEK FIX NOW” has the same meaning as “FIX NOW”

This message appears if Self-Test has passed, but the battery is low. Take the beacon to an

authorized Service Center for a battery replacement.

NOTES regarding Self-Test logic:

1.) When one of the tests fail, the system bypasses the remaining tests

and goes to SELF-TEST FAIL

2.) The only exception to #1 is that if the battery fails, the other tests are

still performed. The system will tell the user if there are other system failures

by flashing SELF-TEST FAIL. If there are no failures other than battery life,

the system flashes SELF-TEST PASS, then BATT LOW.

NMEA

GPS

DATA

SELF

TEST

FAIL

SEE

USER

BOOK

long beep

SEEK

FIX

NOW

BATT

LOW

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 42 43

Sem comentários

ACR Electronics GlobalFix Y1-03-0233 Manual do Utilizador Página 36